7. Reinstall the left and right stairarms onto the crankarms, "Stairarm Assembly Replace-
ment" on page163.
8. Plug
1
in the power cord and switch the power ON.
9. Start a manual workout and operate the machine from min to max speed, min to max
resistance, and min to max incline. Verify that the drive system is operating normally.
That the resistance function and belts operate correctly, no slipping, tracking issues,
or unusual noises.
10. Reinstall the removed rear drive covers: the drive cover access panel, top, left, and
right drive covers (see "Covers and Panels Replacement" on page75).
11. Verify full machine operation and return to service, see ("Operation Verification" on
page19).
1
Device power cord connector or electrical cable male connector that is inserted into an
electrical receptacle "outlet" (also called the plug-in).
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 72
5 Adjustment Procedures
Input Drive Assembly Adjustment
To Next Page
Loading...
Need help?
General
