PRISMJET 54 Gen2 - Page 75

PrismJET 54 Gen2 OPERATION MANUAL Before using
3.6 Adjust Print 85
i. Press the [Enter] key on the operation panel.
• Media thickness value is set.
• “Adj.Print1: Auto” is displayed on the operation panel.
j. Press the [+] key or [–] key to select “Adj.Print2: Standard”.
k. Press the [Enter] key on the operation panel.
• “Adj.1: Confirm Ptn.” is displayed on the operation panel.
• The display enters the Adjust Print menu.
5.1.1.1.3 Adjust Print menu