ProMinent Splash Control Pro 2 - Page 4

8.1.1 ‘Options’ menu........................................................ 80
8.1.2 ‘Inputs’ menu.......................................................... 81
8.1.3 Menu: Configuration and installation of the out‐
puts.......................................................................... 87
8.1.4 Menu: Configuration and installation of the CONDI‐
TIONS...................................................................... 92
8.1.5 Menu: Setting up communication
‘COMMUNICATION’ ............................................... 94
8.1.6 Menu: Configuration and installation of ”Factory
Reset”...................................................................... 94
8.2 ‘SETTINGS’ programming screen............................. 95
8.2.1 ‘Settings’ - ‘OPTIONS’ menu................................. 96
8.2.2 ‘Settings’ - ‘Metering’ menu................................... 96
8.2.3 ‘Hysteresis’ metering mode.................................... 97
8.2.4 ‘Threshold value’ metering mode............................ 98
8.2.5 ‘P.I.D.’ metering mode............................................ 99
8.3 ‘Settings’ - ‘ALARMS’ menu.................................... 101
8.4 ‘Settings’ - ‘CALIBRATE’ menu.............................. 102
8.5 ‘Settings’ - ‘FLOW RATE’ menu............................. 102
8.5.1 Standard version.................................................... 103
8.5.2 Version: Sensors and parameters......................... 104
8.6 Menu - Settings ‘Liquid level storage tank 4 ...
20mA’ ....................................................................... 104
8.6.1 Version: Standard.................................................. 104
8.6.2 Version: Sensors and parameters......................... 105
8.7 ‘Settings’ - ‘TRANSFERS 4 ... 20 mA menu’ .......... 106
8.8 ‘Settings’ - ‘Timer’ menu......................................... 106
9 ‘USER’ programming screen........................................... 107
9.1 ‘User’ - ‘GENERAL SETTINGS’ menu.................... 107
9.2 ‘User’ - ‘DISPLAY’ menu......................................... 107
9.2.1 Automatic display................................................... 108
9.2.2 Manual display....................................................... 108
9.3 ‘User’ - ‘Date and time’ menu................................. 110
9.4 ‘User’ - ‘Language’ menu........................................ 111
9.5 ‘User’ - ‘USB’ menu................................................ 111
9.6 ‘User’ - ‘INPUTS TEST’ menu................................ 112
9.7 ‘User’ - ‘OUTPUTS TEST’ menu............................ 113
9.8 ‘User’ - ‘INFO’ menu............................................... 113
10 Calibrating sensors........................................................... 114
10.1 Calibration menu..................................................... 115
10.2 Calibration status.................................................... 115
10.3 Inputs for calibration............................................... 116
10.4 Validation messages on calibration status.............. 116
10.5 Offset calibration..................................................... 116
10.6 Slope calibration..................................................... 116
10.7 Deleting calibration................................................. 116
10.8 2-point calibration................................................... 117
10.9 Temperature compensation (pH)............................ 117
11 Maintenance/repair........................................................... 118
12 Diagnostics and troubleshooting....................................... 119
13 Disposal of used parts...................................................... 120
Table of contents
4