ProMinent Splash Control Pro 2 - Wi-Fi Configuration [2731]

Modbus RTU
n Selection of Modbus communication mode: this selection
button provides information on the selected mode (RTU). Press
to change the Modbus communication mode.
Speed 19200
n Selection of Modbus communication speed: this selection
button provides information on the selected speed (19200).
Press this key to change the speed.
Parity
n Selection of Modbus communication parity: this selection
button provides information on the selected parity (SANS).
Press this key to change the Modbus communication parity.
Stop bit(s)
n Information on the configuration of the number of stop bit(s).
This option cannot be configured: this option adapts to the
parity configuration. It only provides information intended to
help you with the configuration of your connection.
Address
n Modbus address input of your controller. This is the actual
value (1). Press this selection key to open the number pad and
enter the required value. The possible adjustment ranges from
1 to 247.
Port 520
n TCP port selection: this selection button provides information
on the selected port (520). Press this key to change the TCP
port selection.
Simultaneous connection(s)
n Selection of the number of simultaneous Modbus connections:
this selection button gives the number of simultaneous connec‐
tions. Press this key to change the simultaneous connection(s).
Peripheral Wi-Fi
n Selection of Modbus communication device: this selection
button provides information on the selected device (Wi-Fi).
Press this key to change the selected device.
Pseudo address
n Selection of pseudo Modbus communication address: this
selection button provides information on the selected pseudo
address (255). Press this key to change the pseudo address.
7.5.2 Wi-Fi configuration [2731]
Press the Wi-Fi symbol to open the following screen.
Modbus via RS485
Modbus TCP
Communication programming instructions
63