ProMinent Splash Control Pro 2 - 1 Functional Description

1 Functional description
The swimming pool controller was designed to measure and con‐
trol temperature, pH, chlorine or bromine values using sensors and
the control in conjunction with the corresponding adjustable com‐
ponents of the entire system.
The swimming pool controller will henceforth be referred to as the
‘controller’ throughout these operating instructions.
1.
2.
3.
5.
4.
6.
9.
8.
7.
A1532
Fig. 1: Functional elements of the complete system
1. Swimming pool
2. Metering pump for chlorine
3. Metering pump for acid (pH)
4. Heat exchanger
5. Secondary flow filter for the in-line probe housing
6. In-line probe housing
7. Primary flow filter for the swimming pool
8. Circulating pump
9. Compensation tank
Designation Function Description
Control mode P.I.D. Injection time calculated as a %.
240 second relay injection cycle time.
Hysteresis
All or nothing
Type of actuators Output relay outputs Control of width modulation
Control direction Up or down
Alarms Low and high alarms Expressed in actual measured values.
Control with high and low threshold.
Control Control of flow rate Regulation of injection to control water circu‐
lation.
Storage tank level Regulation of injection to control the height of
the product to be injected.
The key functions
Functional description
6