ProMinent Splash Control Pro 2 - Ethernet Modem Configuration [3731]; Internet and Web Server Configuration [4731]

Mask
n If you disable DHCP, you need to enter the subnet mask of
your network. Press the key to open the numeric keyboard and
enter the required value.
Gateway
n If you disable DHCP, you need to enter the gateway of your
network. Press the key to open the numeric keyboard and
enter the required value.
Automatic DNS
n Selection of the DNS configuration. Press the key to ENABLE/
DISABLE DNS.
Preferred DNS
n If DNS management is not automatic, you need to enter the IP
address of the primary DNS. Press the key to open the
numeric keyboard and enter the required value.
Secondary DNS
n If DNS management is not automatic, you need to enter the IP
address of the secondary DNS. Press the key to open the
numeric keyboard and enter the required value.
Save:
n When a change has been made, the "Backup" button (disk
icon) appears, which you need to press to save your configura‐
tion.
Wi-Fi configuration test
n Press the Connection test key to open the test window.
n The connection phases, module initialisation, and connection
requirement for the selected network are displayed.
n If the connection is successful, the symbol appears green and
the IP address assigned to the Wi-Fi is displayed.
n In the event of an error, the symbol is displayed in red and a
message indicating the type of error is displayed.
Error list
n Password error = Password is incorrect.
n Timeout = Connection failed within the time limit.
n Network not found = SSID network was not found.
n Unknown error => An unknown error has occurred.
7.5.3 Ethernet modem configuration [3731]
This option is not yet available.
7.5.4 Internet and web server configuration [4731]
Press the Internet web service key to open the following screen.
Communication programming instructions
65