5 Commissioning
n User qualification, commissioning: trained user
Ä Chapter 2.4
‘User qualification’ on page 14
The device does not automatically start treating and metering the
chemical product when you switch on the device. Only the user
can initiate operation once they have made sure that the control
unit is programmed in accordance with their needs.
The device is fully configurable. The predefined measuring param‐
eters are displayed and the control processes are disabled when
the device is switched on.
The device is delivered with standard programming. The user
should modify this programming if the programming does not meet
his needs. Refer to the relevant chapter to modify the programming
of your controller.
1. Switch the device on.
2. Check whether everything is in order, your operating panel is
switched on and other elements of your installation have not
been tempered with.
Commissioning
30
To Next Page
Loading...
