Main group Subgroup Function
I: Alarm notifications
1 Technical alarm
2 Measured value too low
3 Measured value too high
4 Disabled setting
Alarm threshold OFF if not programmed
II: Measured value and units
5 Measured value lower than can be displayed on the scale.
6 Measured value higher than can be displayed on the scale.
7 Measured value cannot be displayed.
8 Measured value cannot be measured. Technical alarm
Control setpoint OFF if not programmed
III: Metering status and capacity
9 No metering system available.
10 Metering is stopped (STOP).
11 Metering is paused.
12 No metering in progress.
13 Metering time bar when the maximum metering time is programmed.
IV: Notification area
14 Polarisation is in progress.
15 Check the water supply.
16 The power supply is disconnected.
17 The feed chemical storage tank is empty.
18 Overmetering. Overmetering has been detected.
19 Check the flow or flow volume.
20 The timer is active.
21 The sensor is not operating.
22 The sensor must be maintained and serviced.
23 The sensor signal is unstable and fluctuating.
V: Alarm status area
24 Threshold low / threshold high
25 Measured value
Operating concept and operation
43
To Next Page
Loading...
