PSI PP4050 XP - Refilling the Toner

Maintenance
5-2
5.1.1 Refilling the Toner
By the message 14 TONER EMPTY in the display the printer indicates that the
toner cartridge has to be replaced by a new one.
Note:
The message 16 TONER LOW is only a warning that the printer will run
out of toner soon; but don´t replace the toner cartridge!
Only toner that has been released for the printer must be used. This toner is
part of the before mentioned Toner Kit.
Note:
Take care not to spill any toner inside the printer.
$ Press first . OFFLINE will be displayed.
$ Open the front cover (21) including the Control Panel.
$ Turn the empty toner cartridge (1) clockwise by approximately 180 degrees
until it is fully unlocked.
$ Remove the toner cartridge.
$ Shake the new toner cartridge several times.
$ Insert a new toner cartridge approximate 10 cm, illustrated below, with the
attached plastic seal (3) pointing to the top.
$ Remove the stripe (4) from the cardboard roll (5) and fix it at the begin of the
plastic seal tape (3) .
$ Turn the cardboard roll (5) to roll up the plastic seal (3) until the seal is
entirely removed and push the toner cartridge until it is fully inserted.
$ Turn the toner cartridge (1) counter clockwise by about 180 degrees until it
is fully engaged.
Note:
The cover of the toner cartridge (1) must be locked by the screw (6).
$ Close the front cover (21).
Note:
Don´t refill the toner of the Waste Toner Bottle into the Toner Cartridge!
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es