Appendix A Programming Guide
A-5
A-1.7 Support of Job Separation
Every print job can be separated by a cut operation at the end of the print job. If
the parameter JOBSEPARATION = ON is set either by configuration or by PJL
command every PJL EOJ command triggers a cut operation. The following
example shows how to program the automatic separation of two PCL jobs by
setting the parameter JOBSEPARATION to ON and using the PJL JOB and PJL
EOJ commands at the beginning and end of every PCL job:
ESC%-12345X@PJL DEFAULT JOBSEPARATION = ON
ESC%-12345X@PJL JOB
@PJL ENTER LANGUAGE = PCL
ESC E......PCL job 1.....ESC E
ESC%-12345X@PJL EOJ
ESC%-12345X@PJL JOB
@PJL ENTER LANGUAGE = PCL
ESC E......PCL job 2.....ESC E
ESC%-12345X@PJL EOJ
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...