Explanation of Individual Menu Items
4.3.1 CONFIG MENU
In the Configuration Menu general settings for the printer´s operation are
defined.
$
POWER SAVE
The time until the power save mode is entered can be set to
15
,
30
,
45
,
60
MIN
or
OFF
; factory default is
15 MIN
.
$
OFF
The printer doesn´t switch into the POWER SAVE mode.
In power save mode the printer switches off the fuser lamps, the fans, and
motors. Power dissipation in POWER SAVE mode is
less than 45 watt
. The
messsage
00 POWER SAVE
is displayed. A new print job causes the
POWER SAVE mode to be left.
If there are no new messages to be displayed within the next
15 minutes
the
panel light is switched off as well. This function is independent of the
choosen POWER SAVE time.
$
KEEP TEMP. HIGH
(Keep Fuser Temperature High)
The fuser temperature will not be lowered if a break between print jobs is
shorter than the selected time period; factory default is
1.0
minutes.
Possible values are:
ALWAYS
,
0.5
up to
60
minutes in steps of
0.5
minutes.
Note:
If paper is still in the fuser and a time period
3.5 minutes is selected
the fuser temperature will be lowered after
three
minutes for safety
reasons. This happens also in case
ALWAYS
has been selected.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...