PSI PP4050 XP - Loading the Toner

Installing the Printer and the intelligent Paper Stacker
1-13
1.5.2 Loading the Toner
There is a Toner Cartridge in the Developer Unit.
$ Pull the Toner Cartridge (1) completely off the developer.
Note:
An orange tape (2) is visible which is fixed to a foam block that closes
the toner entrance into the developer.
$ Remove the foam block (2) from the Developer Unit.
$ Shake the Toner Cartridge several times.
$ Insert the Toner Cartridge (1) approximate 10 cm, illustrated below, with the
attached plastic seal (3) pointing to the top .
$ Remove the stripe (4) from the cardboard roll (5) and fix it at the begin of the
plastic seal tape (3) .
$ Turn the cardboard roll (5) to roll up the plastic seal (3) until the seal is
entirely removed and push the toner cartridge until it is fully inserted.
$ Turn the Toner Cartridge (1) counter clockwise by about 180 degrees until it
is fully engaged.
Note:
The cover of the Toner Cartridge (1) must be locked by the screw (6).
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es