Configuring the Printer
3-3
3.2 Printout of Standard Configuration
The factory default configuration can be printed within the TEST MENU and is
shown on the following page.
The upper part of the SELFTEST printout shows the actual selections and
parameter values.
Main functions appear in the first line of each menu block.
Second and following lines show the selection at subfunction level and the
selected parameters behind the "=" sign.
Below the menu section on the test page information is given about the
hardware and software configuration of the printer and stacker is given:
$
FLASH memory size for printer firmware and fonts
$
memory size (DRAM)
$
Printer and Stacker firmware version
$
Panel version
$
available emulations
The rest of the page is filled up with a diagonal test pattern. The black frame
around the test page reflects the actual paper format. The default format is 12
inch for paper length and 16 inch for image width.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...