PSI PP4050 XP - 6 Troubleshooting and Diagnostics; How to Use this Section

6-1
6
Troubleshooting and Diagnostics
How to Use This Section
1.
Find the category to which your problem belongs. The problem
categories are:
$
Power-related Problems
$
Error Messages
2.
Find the symptom description that most closely matches the printer
symptom.
3.
Try the first suggestion under that heading.
4.
If none of the suggestions enables you to continue printing, or if the fault
is not listed, contact your service agent. Every time the printer is
switched ON an internal selftest is started.
After power
ON
the display signals the message:
Memory-Test!
Please wait ...
After successful completion two messages pop up on the display shortly after
each other, with n = 1 to 10 (number of the last choosen Profile):
OFFLINE (n)
PCL
Then all fields of the display shortly show black squares and a short beep
sounds; power
ON
is indicated by the green LED at the control panel.
The following message appears:
ONLINE (n)
WARMING UP
Then the display changes into:
ONLINE (n)
If an error message is displayed please refer to section 2.3
Status and Error
Messages
and 6.2
Error Messages
.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es