PSI PP4050 XP - Page 127

Troubleshooting and Diagnostics
Display
That means...
Measure
6-5
36 STACKER BUSY
The Paper Exit Tray of
wait
the iPS is moving up and
down and stopps at
working position
37 WRONG PG. LENGTH
If
PAPER LENGTH
in
See in Chapter
4.2.1
the
PAPER MENU
is set
PAPER MENU
the
to a value less than 7
parameter
LENGTH
inch or greater than 17
FACTOR
inch the
WRONG
PAGELENGTH
message
After pressing
the
is displayed.
printer continued the print
If the paper length is less
job.
than 7 inch the
A correct stacking can not
movement of the
be guranteed since the
pendulum will be for a
paper length is exceeding
page length of 7 inch,
the operating range of the
and greater than 17 inch
stacker.
a movement for a page
length of 17 inch.
38 STACKER ERROR
Error when reading the
In case of a malfunction of
EEPROM of the stacker.
the pendulum new paper
The stacker is further
must be inserted because
operational but the
the information about the
paramter setting after the
paper felt has been lost.
last power off has been
Error still there: call service.
lost.
39 EEPROM LIFE
Warning: The typical life
After pressing
the
cycle of the EEPROM is
printer continued the print
reached. The stacker is
job.
further fully operational
Call service to change the
until a program error
EEPROM
occurs. The EEPROM
should be changed
52 SERVICE FUSER
n
Problem with the Fuser;
Power off and on; if error
n
=
still there replace the Fuser
16
The main heater is
Unit (see Chapt.
5.3.1
) or
unusually in high
call service
temperature.
32
The main heater is
unusually in low
temperature.
64
The main heater is
warming up, but
does not reach the
selected temperature
within a given time.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es