PSI PP4050 XP - Page 132

Troubleshooting and Diagnostics
Display
That means...
Measure
*)
After replacing the Developer Unit, the PC Cartridge, or the Fuser Unit
the Reset functions (CONFIG MENU

BASIC SETTINGS) have to be
called up.
Remove all transportation locks before replacing the units.
6-10
80 EXCHANGE OPC
PC-Cartridge has
Replace the PC-Cartridge *)
reached its end of life
82 EXCHANGE DEVELOPER
Developer has reached
Replace the Developer *)
its end of life
83 EXCHANGE FUSER
Fuser has reached its
Replace the Fuser *)
end of life
90 LD STACKER Vx.xx
Message during loading
a new stacker firmware
91 UPD. STACKER FW
Message during loading
the stacker firmware
92 STACK. COM ERROR
Communication error
- Check power cable
between printer and
- Check interface cable
stacker;
- Power OFF/ON again
Cable defective
93 STACK. PROG. ERR
Program error in the
- Power OFF/ON again
stacker
- Call service to load
new firmware
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es