PSI PP4050 XP - Page 71

4-2
$
SELECT FOLD LOWER
$
$
SELECT FOLD UPPER
The standard setting for both tractors is
POSITIVE
fold. In this case check
that the fold behind the first page is a positive one (fold points outwards). If
not tear off one page and insert the paper again beginning with a positive
fold.
If it is not possible to lose a page use this parameter to change the standard
setting to
NEGATIVE
.
Note:
This fold setting must occur every time when paper is newly inserted.
$
$
CHANGE PROFILE
To change one out of 50 possible set up parameter blocks called
Profiles
,
determining the application specific printer set up.
Note:
Each profile contains all print job relevant set up parameters
specifying the features and functions grouped into different
submenus like PAPER MENU, PCL MENU, and GENERAL MENU.
For details see chapter 4.2.
$
$
BASIC SETTINGS
In this menu mode it is possible to configure all the basic operation related
features of the Printer (e.g.
Power Save
,
Keep Temperature High
, or
Menu Access).
$
TEST MODE
This function initiates a printout of the parameter settings, Profile definitions,
and PCL typeface list. This printout is helpful for future reference and in
case a Profile need to be changed.
$
RESET PRINTER
If it is necessary to cancel a print job and reset the printer use this function
by setting the value to
YES
. After resetting the printer changes atomatically
to
NO
.
Note:
Before starting this function, cancel the print job on the host system!
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es