Qlogic 8100 Series User Manual

3–Installation in a Windows Environment
Installing Software
3-18 FE0254601-00 A
b. To install the driver, right click Ethernet Controller, and then click
Update Driver Software (Figure 3-19).
Figure 3-19. Installing an NIC Driver—Windows 2008
6. If you are updating QLogic adapter drivers:
a. Click Network Adapters (for NIC drivers). Find each port of the
QLogic adapter NIC function that is listed as QLogic10Gb PCI Ethernet
Adapter under this section. Figure 3-20 shows typical entries for a
dual-port QLogic 8100 Series Adapter.
Figure 3-20. Typical Ethernet Adapter Port Entries for Windows 2008
b. To update the driver, right click QLogic10Gb PCI Ethernet Adapter,
and then click Update Driver Software (Figure 3-21).
Figure 3-21. Updating an NIC Driver for Windows 2008

Qlogic 8100 Series Specifications

General

Brand	Qlogic
Model	8100 Series
Category	Network Card
Language	English