Qlogic 8100 Series

3–Installation in a Windows Environment
Installing Software
FE0254601-00 A 3-21
b. To install the driver, right click Fibre Channel Controller, and then
click Update Driver Software... (Figure 3-25).
Figure 3-25. Installing an FCoE Driver for Windows 2008
6. If you are updating QLogic adapter drivers:
a. Click Storage controllers (for FCoE drivers). Find each port of the
QLogic adapter FCoE function that is listed as QLogic FCoE Adapter
under this section. Figure 3-26 shows typical entries for a dual-port
QLogic 8100 Series Adapter.
Figure 3-26. Typical QLogic 8100 Series Adapter Port Entry
b. To update the driver, right click QLogic FCoE Adapter, and then click
Update Driver Software… (Figure 3-27).
Figure 3-27. Updating an FCoE Driver for Windows 2008