Setup Unpacking
CubiScan 110 7
3. Remove the packing material from around the CubiScan.
4. Gently lift the CubiScan from the crate (this may require two
people).
If, after unpacking, you discover any damage to the CubiScan 110,
contact the carrier immediately.
Remove any tape or ties used to fasten cables to the scale platter for
shipment.
The CubiScan is shipped in a single container with the following
items.
• Fully assembled CubiScan 110
• AC power cord
• RS-232 communications cable
• Qbit software CD (optional)
• Operations and Technical Manual (this manual)
Accessories and tools packed with the CubiScan 110 include the
following:
• 2.5 mm allen wrench
• 4.0 mm Allen wrench
• 5.0 mm Allen wrench
• 6.0 mm Allen wrench
• 12" x 5" x 3.6" calibration block
• Bubble level
If any of the components or accessories are missing or defective,
contact Quantronix or your system integrator.
To Next Page
Loading...
Need help?
General
