Radwin 2000 C PLUS - Page 104

RADWIN2000CPlusUserManual Release3.5.70 6‐42
TelnetAccesstotheSlaveODU Chapter6
setwritepw<oldpasswd><passwd>
Settheread‐writeaccesspassword(Read‐Write
Community)
settrappw<oldpasswd><passwd> SetthetrapCommunitystring
setbuzzer
<mode:0=OFF,1=AUTO,2=ON>
Setthebuzzermode
settpc<power:Valuebetween
minimalTxpower,andmaximalTx
power>
SettheODUTxPower.Ifawrongvalueisentered,
bothminandmaxvaluesshallbedisplayedinthe
errorreply
setname<newname> Setthenameofthelink
setlocation<newlocation> Setthenameofthelocation
setcontact<newcontact> Setthenameofthesitemanager
setethernet<port:LAN1>
<mode:AUTO,10H,10F,100H,100F,D
ISABLE>
SetthemodeandspeedoftheEthernetport
reboot
ResetstheODU.Theuseriswarnedthatthe
commandwillre settheODU.AnewTelnetsessionto
theODUmaybeopenedaftertheresetiscomplete.
help Displaysthe availablecommands
Table6‐10:SlaveODUTelnet‐SetCommandsrequiringReset
Command Explanation
setsecId<SectorID> SetnewsectorID‐Resetrequired.
Table6‐9:SlaveODUTelnet‐SetImmediateCommands(Continued)
Command Explanation