Radwin 2000 C PLUS - Figure 10-6 Hss Sync Signal; Figure 10-7 Cascading Two

RADWIN2000CPlusUserManual Release3.5.70 10‐5
UsingMorethanOneHSSUnit Chapter10
Figure10‐6:HSSsyncsignalpathwithODU1asHSSMaster
UsingMorethanOneHSSUnit
Inalargecollocationsite,severalHSSunitsmaybecascaded(daisy‐chained)subjecttothe
followingconditions:
Condition1:CablingSequence
1. UptonineODUsmaybeconnectedtothefirstHSSunitusingHSSportsSYNC1,SYNC2,
SYNC3,...uptoSYNC9inorderwithoutleavingemptyports.
2. ThenextavailableSYNCportofthefirstHSSunitshouldbeconnectedtoSYNC10
ofthesecondHSSunitasshowninFigure 10‐7.Intheillustration,thenext
availableportonthefirstHSSunitisSYNC6.
3. ThesecondHSSunitmaybefilledoutwithuptoninemoreODUsinreverseorder.
Thatis,connectSYNC9,SYNC8,SYNC7...asshowninFigure 10
‐7.
Figure10‐7:CascadingtwoHSSunits