Radwin 2000 C PLUS - Throughput Checking

RADWIN2000CPlusUserManual Release3.5.70 9‐3
ThroughputChecking Chapter9
ThecontentoftheDiagnosticsreportisanaggregateofallthemorespecificreports
discussedbelow.ItisprimarilyintendedforusebyRADWINCustomerService.
Throughput Checking
Inthismode,RADWIN2000CPlusestimatesEthernetthroughputbyfilling framesoverthe
airtomaximumfor30seconds.Thismodeshouldnotinfluenceservice.
 TouseThroughputChecking:
1.ChoseEstimatedThroughputfromtheToolstab:
Note
TheSpectrumAnalysisoutputisavailabledirectlyfromtheSpectrumView
utilityasaCSVfile(seeSpectrumView).TheformatintheDiagnostics
reportisintendedforusebyRADWINCustomerService.
TheSpectrumAnalysissectionoftheDiagnosticsreportisbasedonthelast
availablespectrumanalysis(ifany).Ifyouaresubmittingasupportrequest
involvinginterferenceissues,orifyouarespecificallyask edbyCustomer
ServicetosubmitaDiagnosticsreportcontainingarecentspectrum
analysis,youshouldcarryouttheanalysisinaccordancewiththeSpectrum
ViewinstructionspriortousingtheGetDiagnosticsfacility.