Radwin 2000 C PLUS - Registering the Slave ODU

RADWIN2000CPlusUserManual Release3.5.70 6‐12
RegisteringtheSlaveODU Chapter6
Figure6‐3:Mainwindow:Mast erODUactivated,SlaveODUreadyforregistration
12.IfyouareusingLocalConnection,logoutandlogbackintotheHBSonitsIP
address.
Youmayha veobservedthatoperatingfrequency5.790GHzshown,isnotwhatwechose
(5.820GHz).TheMasterODUtriestooptimizethefrequencytominimizeinterference
effects.
WenextregisterandconfiguretheSlave ODU.Manyoftheconfigurationandservice
parametersmaybesetpriortoregistration.Duringlinkestablishmenttheorderdoesnot
matter.However,manyconfigurationchangestoalinkafterregistration, willaffecttrafficor
evenresetthelink.
RegisteringtheSlaveODU
InFigure 6‐3,clicktheRegistrationbutton.Youareaskedtochoosetheantennatype:
Afterfewmoments,theregistrationprocesscompletes.Hereisthestatusofthelink: