Radwin 2000 C PLUS - Figure 6-20 Bulk Backup Setup; Figure 6-21 Add; Remove Site; Figure 6-22 Adding Asingle

RADWIN2000CPlusUserManual Release3.5.70 6‐33
BulkSoftwareBackup Chapter6
Thefollowingdetachedwindowappears:
Figure6‐20:BulkBackupsetupwindow
ThedefaultsitesshownintheBulkBackuplistpanelbelongtothecurrentlyinstalled
link.ThelistmaybeemptyifyouarerunningtheRADWINManager“offline”.
2.TheBulkBackuplisttitlebarhasthreebuttonsontherighthandside.
Figure6‐21:Add/Removesitebuttons
TheleftbuttonopensupaWindowsfiledialogtolocatealistoflocationstobackup.
Thelisthasthefollowingformat:
<IPaddress>,<Read‐Onlycommunity>,<Read‐Writecommunity>
Forexample:
10.104.4.2,netman
10.104.4.4,netman
Thecenterbuttonallowsyoutoaddasinglesite:
Figure6‐22:Addingasinglesiteforupgrade
EntertheIPaddressofthesite,theRead‐WriteCommunity(Default:netman)and
thenclickOK.ThesitewillappearintheSoftwareUpgradelistbox.