Radwin 2000 C PLUS - Using the Web Interface

RADWIN2000CPlusUserManual Release3.5.70 20‐1
Chapter20:
UsingtheWebInte rface
WhatisitFor
TheWebInterface(WI)enablesyoutocarryoutbasiclinkmanagementfunctionsusinga
Webbrowser.
Itmaybeusedto‐
• Monitoralinkonaminimalbasis
• Checklinkparametersandmakelimitedchanges
• ViewthelinkInventory
• InspecttheRecentEventslogs
WhoNeedsit
TheWIisatoolfortechniciansto“quick‐install”anODUinalinkwithminimumeffort.
Itmayalsobeemployedbyauserforaquicklookatcurrentoperatingparametersandthe
RecentEventslogs.
HowitWorks
Assume the link setup, which we used in LinkConfiguration and later.
Onthemanagingcomputer,pointyourbrowserto10.104.4.2andlogonasshownbelow.You
canalsologonovertheairtotheSlaveODUinthesameway.
Forstand‐aloneorunregisteredODUs,youmustconnectamanagingcomputerdirectlyto
theODUandagainlogonasshownbelow.