Radwin 2000 C PLUS

RADWIN2000CPlusUserManual Release3.5.70 6‐1
Chapter6:
LinkConfiguration
ChapterContents
ThischapterisdividedintotwosectionscoveringthetwophasesofLinkconfiguration:
1. Linkestablishment:Initialsetup
2. Linkmaintenance:Finetuningandspecialfunctions
Linkestablishmentistypicallyaonce‐onlytask.Linkmaintenanceisrequiredforfine‐tuning
thelinkandconfigurationofspecialfeaturessuchasVLAN,QualityofServiceandmore.
LinkEstablishment
LinkConfigurationWorkflow
TheworkflowrequiredtoestablishalinkderivesfromtheprecedentsoftheRADWIN2000C
PlusfamilyintheRADWIN5000PointtoMultipointtechnology.
Assupplied,bothODUsarefactorypre‐configuredasHSUs.Oneofthem,typicallytheoneto
whichyouloggedoninthepreviouschapter,mustbedefinedasLinkMasterODU.
TheLinkMas terODUrequiresactivation.TheODUwillcommencetransmittingandreceiving
pack etsrelatedtolinkmanagementonly‐thatisnoservice.ActivationandDeactivationare
effectedquitesimplybyclickingatogglebutton.
AssumingthattheODUintendedasLinkSlaveODUis
mountedalignedandpowe redup,it
willdiscovertheMasterODUestablishingalinkformanagementonly.AtthispointtheSlave
ODUmaybemanagedovertheair.
HavingIdentifiedtheLinkSlaveODU,thelattermustberegisteredtotheMasterODUto
enabletrafficbetweenthem,completingphase1.
Followingregistration,youcansetseparately,
• MIMOmode
• Transmissionratiobetweenuplinkanddownlink