Radwin 2000 C PLUS - Assigning Queue Priorities

RADWIN2000CPlusUserManual Release3.5.70 16‐4
AssigningQueuePriorities Chapter16
AssigningQueuePriorities
 Toconfigurequeueprioritiesforuplinkanddownlinkinturn:
1.Foreachqueue,bothdownlinkanduplinkent ertherequiredweightandMIR.The
lattermaybeleftunlimited.inwhichcasethesystemwillusea“besteffort”
method.
Ifyouexceed100%totalweight,youwillreceiveanerrormessage.
Youwillberequiredtocorrectthisbefo releavingthewindowotherthanbycancel‐
lation.
Ifyouareunder‐booked,forexamplebysettingaqueuetozero,theunusedweight
willbedistributedtotheremainingqueues.Theeffectofdoingthiswillonlybecome
apparentundercongestion.Inparticular,aqueuesettozeroweightwillbecome
nearlyblockedundercongestionwithpacketspassingthroughonabesteffortbasis.
2.Whenyoucompleteyourentries,intheQoSConfigurationwindow(Figure 16‐
1),clickOKtosavethemandcontinue.