Radwin 2000 C PLUS - Page 89

RADWIN2000CPlusUserManual Release3.5.70 6‐27
ChangingtheLinkBand Chapter6
7.ClickOK.Alinkre‐syncfollows.Hereisthefinalresult:
Havingsetthechannelbandwidthandoperatingchannelsearlier,thereisnoneed
fordeactivationandreactivation.
YoumayalsoaddnewBandsbyclickingtheAddBandsbutton.Thereareseveralprovisosto
this:
• AdditionalBandsmust
beavailableforyourhardware
• SuchadditionalBandsmustbeavailablewithintheframeworkofyourlocalregulations
TheforegoingappliestobothregulatedandunregulatedBands.
 Toobtainandinstalladditionalbands:
1.AsInstaller,openthewindowofFigure 6‐15above,andclickAddBands.Thefollow‐
inginstructionpanelisdisplayed: