Radwin 5000 HPMP - Registering a Nomadic HSU for Service

RADWIN5000HPMPUserManual Release3.5.70 6‐32
RegisteringanomadicHSUforservice
ObservethattheregisteredHSUiconLEDisnowgreenandthatthetimeslotsbaron
theleftreflectstheproportionofuplinkanddownlinktimeslotsallocated.
9.Repeatsteps1to8forotherfixedHSUs.
Registeringanomadic HSUforservice
AlthoughweonlyhaveonenomadicHSUinourdemonstrationsector,inpracticewewould
makeprovisionforalargernumbertoenablemovementbetweensectors.Bywayof
example,wewillpre‐registerfourHSUslotstolevelsA,BandCandtimeslotstoeachlevelas
shown:
 ToconfigurenomadicHSUsfromtheHBS:
1.OpentheHBSConfigurationwindowandthenitsNomadicTab:
Figure6‐9:HBSNomadicConfiguration