Radwin 5000 HPMP - Configuring AES 256 Encryption Support

RADWIN5000HPMPUserManual Release3.5.70 8‐54
ConfiguringAES256EncryptionSupport
Afewminuteslater,youshouldreceiveanemail,containinginitsbody,alistof
licensekeys.
7.CopyandPastethelicensekeysintoaplain textfileandsaveittoasafeknownplace.
8.OpentheConfigure|Operationstab(Figure 8‐16).ChecktheLicenseFilebuttonand
navigatetothefileyousavedinthelaststep.
9.ClickActivate.ThenexttimeyouentertheChangeBandstab,thenewbandswillbe
available.
ConfiguringAES256EncryptionSupport
AES256supportisperHSUbutenabledfromtheHBS.
 ToenableAES256Encryptionsupportforasector:
1.EnsurethattheHBSishardwarereadyforAES256:FromtheHBSConfigurationbut‐
ton,opentheInventorypageandcheckthatthehardwareversionis9orhigher.
Openatextfileandcopy/pastetheserialnumberoftheHBStoit.
2.DeterminewhichHSUsrequireAES256support.FromtheInventorypageforeach
HSU,checkthatthehardwareversionis9orhigher.Copy/pastetheserialnumberof
theHSUtothetextlist,oneserialnumberperline.Alternatively,usethecapture
buttoninlistmodeattheHBStocopypastealistofHSUs.
Inanyevent,youmuststillcheckthehardwarelevelofeachlistedHSU.
3.Savethetextfileandsendittoyourequipmentsupplierwithyourlicensepurchase
order.
4.Youwillreceivebyreturnemailatextattachmentshowingserialnumberandlicense
key .Savethefiletoaknownsafelocation.
5.AttheHBS,opentheConfiguration|Operationstab(Figure 8‐16).ChecktheLicense
Filebuttonandnaviga tetothefileyousavedinthelaststep.
Note
YoumayseeerrormessagesintheStatusColumnsuchasBandnot
supportedorSerialnotfound.Supportedbandstypicallyreflectyourlocal
regulations.CheckmissingserialnumberswithRADWINCustomerService.