Radwin 5000 HPMP - Throughput Checking

RADWIN5000HPMPUserManual Release3.5.70 12‐6
SoftwareUpgraderecommended
SoftwareUpgraderecommended
Thisisalsoanadvisorymessage.IttypicallyoccurswithanewHBSornewHSUsaddedtoa
sector.
Iftheupgradeisnotcarriedout,thentheHBSorHSU(s)willoperatewithlimitedor
degradedfunctionality.ThismessagemayappearforanactiveHBSoranyHSUinthesector,
registeredornot.
SoftwareUpgraderequired
Thismessagewill bedisplayedifaproductbandIDmismatchisdetected.
ThusforaHBS,itcannotoccurunlessoneormoreHSUsareregistered.AffectedHSUswill
alwaysshowitasdepictedaboveinFigure 12‐4above.
ForsuchHSUs,trafficisdisabledandtheonlyservicesavailableareChangeBandand
SoftwareUpgrade.
ThroughputChecking
Inthismode,RADWIN5000HPMPestimatesEthernetthroughputbyfillingframesoverthe
airtomaximumfor30seconds.Thismodeshouldnotinfluenceservice.Thetestmaybe
carriedoutfortheHBSoranHSU.
 TouseThroughputChecking:
1.HBS:ChoseEstimatedThroughputasshown:
HSUfromHBS:ChoseEstimatedThroughputasshown: