Radwin 5000 HPMP - Which Type of HSS to Use

RADWIN5000HPMPUserManual Release3.5.70 13‐5
RFP:GeneralRadioFramePattern
SelecttheRFPthatgivesyoutheBestFitorAvailableforrequiredsystemservicesandselect
thechannelbandwidthaccordingly.
RFP:GeneralRadioFramePattern
WhensettingtheRPF,thefollowingconsiderationsshouldbeborneinmind:
• WhensynchronizingRADWIN5000HBSunitsyoumustuseRFPE
• WhensynchronizingRADWIN5000HBSwithRADWIN2000orWinLink1000unitsyou
mustuseRFPE
• RFPinfluencescapacityandlatency.
• UsingtheLinkBudgetCalculator,youcanseetheeffectoftheRFPontheEthernet
throughput.
WhichTypeofHSStoUse
YoumayusebothformsofHSSwiththeHBS.Therearehoweversomelimitations:
• IfyoucollocateanHBStobothaunitsupportingSHSSandHSSoE,theHBSmustalways
beHSM
• IfyoucollocatewithaGSU,youcanonlyuseHSSoEandtheGSUmastbeHSM.
Table13‐3:LegendforRadioFramePatternTables
Item Description
Bestfit OptimalRFPchoiceforTDMandEthernetservices
Available AvailableRFPforTDMandEthernetservices,butnotoptima
N/A Serviceunavail able
Note
TheRFPmustbethesameforeachlinkwithinthecollocatedsystem.