Radwin 5000 HPMP - Interface API; Private MIB Structure

RADWIN5000HPMPUserManual Release3.5.70 C‐2
InterfaceAPI
InterfaceAPI
ControlMethod
TheRADWINManagerapplicationprovidesallthemeanstoconfigureandmonitora
RADWIN5000HPMPlink,communicatingwiththeSNMPagentineachODU.EachSNMP
agentcontainsdataoneachofthePoEsandODUsinthelink.Bothagentscommunicatewith
eachotherovertheairusingaproprietaryprotocol.
TocontrolandconfigurethedeviceusingtheMIB,youshouldadheretothefollowingrules:
• Theconnectionforcontrolandconfigurationistothelocalsite,overanySNMP/UDP/IP
network.
• AllParametersshouldbeconsistentbetweenbothoftheODUs.Notethatinconsistency
ofairparameterscanbreaktheairconnection.Tocorrectairparametersinconsistency
youmustreconfigureeachoftheODUs.
• Commonpracticeistoconfiguretheremotesitefirstandthentoconfigurethelocal
site.
• Forsomeoftheconfigurationparametersadditionalactionmustbetakenbeforethe
newvalueisloaded.Pleaserefertotheoperationintheparametersdescription.
• SomeoftheMIBparametersvaluesareproductdependent.Itisstronglyrecommend
usingtheRADWINManagerApplicationforchangingthesevalues.Settingwrongvalues
maycauseindeterminateresults.
CommunityString
Tocontrolalink,allSNMPrequestsshouldgotothelocalsiteIPaddress.
SeeTable 5‐6fordefaultCommunitystrings.
PrivateMIBStructure
ThesectionsintheprivateRADWINMIBanditslocationintheMIBtreeareshownin
Figure C‐1below:
Note
EachODUhasasingleMACaddressandasingleIPaddress.