Radwin 5000 HPMP - The RADWIN Manager Log-On Concept; Figure 5-3 Log on Window -Ipv; Figure 5-4 Log - on Window - Ip

RADWIN5000HPMPUserManual Release3.5.70 5‐8
TheRADWINManagerLog‐onConcept
Figure5‐3:Log‐onwindow‐IPv4
Figure5‐4:Log‐onwindow‐IPv6
TheRADWINManagerLog‐onConcept
RADWIN5000supportsSNMPv1andSNMPv3eitherseparatelyortogether.Thelog‐on
procedurediffersslightlybetweenoperationunderSNMPv1andSNMPv3.Inwhatfollows
below,weassumethatSNMPv1isinuse.InTable 5‐6atendofthesection,weshowthe
differencebetweenSNMPv1andSNMPv3atlog‐ontime.
TheRADWINManagerprovidesthreelevelsofaccessinoneoftwoentrymodes.Tosee
them,clickOptionsatanytimeintheLogonwindow(Figure 5‐3above).Youareofferedan
extendedlog‐onwindow: