Radwin 5000 HPMP - Configuring an HSU from the HBS Main Window

RADWIN5000HPMPUserManual Release3.5.70 8‐31
ConfiguringanHSUfromtheHBSMainWindow
Figure8‐17:HSUIntercommunication‐ConnectionTable
Thegreenshadedsquaresshowintercommunicatingelementswithinthesector.MNGrefers
tomanagementtrafficwhichshouldalwaysbeopenbetweenHSUsandtheHBS.LANrefers
toservicetrafficbetweentheHBSandtheHSUs.Asshown,thetwoHSUsmaynot
communicatebetweenthemselves.Clickingthetopwhitesquarewouldenable
communication(viatheHBS)betweenthem.
YoumayinfactdisablealltrafficbetweentheHBSandtheHSUsandrestoreitusingthis
device.
ConfiguringanHSUfromtheHBSMain
Window
RightclickanHSUforitscontextmenuandclickConfiguretoopentheHSUConfiguration
window.
ConfigurationMenuButtons