Radwin 5000 HPMP - Safety Practices and Provisions

RADWIN5000HPMPUserManual Release3.5.70 4‐13
Cablesandconnectors
• Cableties
• Sealingmaterial
• WaterproofingtapesuchasScotch23Tape¾”wide,from3MtoensureIP‐67compliant
protectionagainst wateranddust
Cablesandconnectors
• ODUgroundingcable10AWG
• ODU‐PoEcable(outdoorclass,CAT‐5e,4twistedpairs,24AWG):
• Upto100m.for100BaseTconnection.
• Fora1000BaseTconnection(HBSonly)useanODU‐PoEcablenolongerthan75m.
• ExternalCAT‐5ecablediametershouldbebetween7‐9mmtoensurewaterproof
sealing.
SafetyPracticesandProvisions
PreventingOverexposuretoRFEnergy
ToprotectagainstoverexposuretoRFenergy,installtheODUssoastoprovideandmainta in
minimalseparationdistancesfromallpersons.
Whenthesystemisoperational,avoidstandingdirectlyinfrontoftheantenna.StrongRF
fieldsarepresentwhenthetransmitterison.TheODUmustnotbedeployedinalocation
whereitispossibleforpeopletostandorwalkinadvertentlyinfrontoftheantenna.
Grounding
AllRADWINproductsshouldbegroundedduringoperation.Inaddition:
• AllODUsshouldbeearthedbyawirewithdiameterofatleast10AWG.
RADWIN5000HPMPODUsmustbeproperlygroundedtoprotectagainstlightning.Itis
theuser'sresponsibilitytoinstalltheequipmentinaccordancewithSection810ofthe
NationalElectricCode,ANSI/NFPANo.70‐1984orSection54oftheCanadianElectrical
Code.Thesecodesdescribecorrectinstallationproceduresforgroundingoutdoorunits,
masts,lead‐inwiringanddischargeunits.Italsolaysdownthesizeofgrounding
conductorsandconnectionrequirementsforgroundingelectrodes.RADWIN5000
HPMPODUsmustbegroundedtoaProtectiveEarthinaccordancewiththeLocal
ElectricalRegulations.
Note
For1000BaseT,youshoulduseRADWINsuppliedODU‐PoEcables,which
guarantees1Gbperformance.RADWINcannotguarantee1Gb
performanceifyouusethirdpartycables.