Radwin 5000 HPMP - Figure 4-29 Exposing the Tacky Side of the Sealing Tape; Figure 4-30 Start and End Points for Protective - Taping the Unit

RADWIN5000HPMPUserManual Release3.5.70 4‐23
InstallingtheBaseStation
Figure4‐29:Exposingthetackysideofthesealingtape
3.AfterconnectingtheshortCAT‐5eIDU/ODUcable(providedinthebox)fromthe
ODUtotheunit,tightenthecableglandcapfirmlyandusetheinsulationtape
scotch23tofullycoverbothofthecableglands.
4.ConnectthetapewithtackysideuponthecableglandcapandtheCAT‐5ecable.
StartatStartPointatthebottomofthecableglandasshowninFigure 4‐30.Finish
atEndPointoftheCAT‐5ecable,2.5cmaftertheendoftheshrinktubing.Stretch
thetapeandapplyhalf‐overlappedtoformgap‐freejoint.
Figure4‐30:StartandEndpointsforprotective‐tapingtheunit
5.Wraptwolayersofan yscotchvinylplasticelectricaltype(e.gScotchSuper88Vinyl
PlasticTapefrom3M)toprotectthejointsasshowninFigure 4‐31.Ensurethatthe
bottomofthecableglandandtheendoftheCAT‐5ecablearecoveredwiththe
sealingsplicingtapeandwithvinylplastictape.