Radwin 5000 HPMP - Installation Procedure

RADWIN5000HPMPUserManual Release3.5.70 4‐33
InstallationProcedure
InstallationProcedure
UnpackingandChecking
 Foreachoftheitemsbelow,dothefollowing:
1.Removetheequipmentfromthebox.
2.CheckthateverythinglistedontheincludedBillofMaterialsorPro‐formaInvoiceis
present.
3.Ifanyitemismissing,contactCustomerService.Youwillbeadvisedwhetherto
returnthepackageforreplacement,orwhetherthemissingitemcanbesupplied
separately.
4.Donotdisposeofthepackaginguntiltheunitisinstalledandoperational.
ToolsandAdditionalMaterials
• Spanner/wrench,screwdriversvarious(primarilyforsmallelectricalconnections)
• Drill
• SealingmaterialorotherwaterproofingtapesuchasScotch23Tape¾”wide,from3M
toensureprotectionagainstwateranddustforcableentryintothevehicle.
Installation
MounttheVMUinasafeprotectedlocation.Theambienttemperatureshouldbeinthe
range‐35°Cto+60°C(‐31°Fto+140°F).
 TopreparethevehicleforVMUinstallation:
1.LocateandmarktheVMUintheplacewhereyouwanttomountit.
2.Determinethepreciselocationoftheantennasontheroof‐top.
3.RoutethecablesfromthevehiclebatteryareatotheVMUlocation.
4.RoutethecablesfromtheantennalocationtotheVMUlocation.
5.RoutethecablesfromthecabinPC/CameratotheVMUlocation.
 TophysicallymounttheVMU:
1.Placetheunitagainstthesurfacetowhichitistobemounted.
2.Markthescrewplacementsusingfourofthemountingholesintheunitasguides.
3.Drillholesinthesurfaceusingyourmarks.
Note
ForM12connectors,usealockingtorqueof0.49Nm.