Radwin 5000 HPMP - Tools Required for Installation; Figure 4-21 Using an Ethernet Repeater with Lightning Protectors

RADWIN5000HPMPUserManual Release3.5.70 4‐12
Toolsrequiredforinstallation
EthernetcableRepeater
TheRADWINEthernetrepeaterenablesyoutoextendthePoEtoODUcablebeyondthe
100mlimit(butnomorethan200m).Theunitissimilarinappearancetothelightning
protectiondeviceinFigure 4‐20.Itsuseisverysimpleasshowninthefollowingschematic:
Figure4‐21:Using
anEthernetrepeaterwithlightningprotectors
Toolsrequiredforinstallation
ThefollowingisalistoftheequipmentandmaterialsrequiredtoinstallRADWIN5000HPMP
hardware.
ToolsandMaterials
• CrimpingtoolforRJ‐45(iftheODU‐PoEcableiswithoutconnectors)
• Spanner/wrench13mm(½”)
• Drill(forwallmountingonly)
Note
TheEthernetrepeatercannotbeusedwithGbEIDU‐ODUcables.