Radwin 5000 HPMP - Figure 4-28 Basic Use of Lightning Protectors

RADWIN5000HPMPUserManual Release3.5.70 4‐21
InstallingtheBaseStation
Figure4‐28:Basicuseoflightningprotectors
 ToinstallaLPUonapoleadjacenttoanODU(HBSorHSU):
1.MountoneLPUonthe
ODUpole,ascloseas
possibletotheODU.
2.GroundtheLPUtothe
poleusingthegrounding
lug.
3.Connectthe0.5met er
CAT‐5ecabletotheIDU
port
oftheODU.
4.Connecttheotherendof
thecabletothetopof
theLPU.
5.TightenthetopcableLPU
glandcap.
6.ConnectthemainODU‐
IDUcablefromtheIDUtothebottomendoftheLPU.
7.TightenthebottomcableLPUglandcap.
8.RunthemainODU‐IDUcabletowardstheIDUlocation.
9.InsulatebothLPUconnections.Seethenextsection,AdditionalConsiderationsfor
Waterproofing below.