Radwin 5000 HPMP - Page 158

RADWIN5000HPMPUserManual Release3.5.70 8‐3
AirInterface
AirInterface
ThispanelhassimilarfunctionalityasthecorrespondingwindowintheActivationWizard
(seeChapter6).ChangingtheSectorIDwill“percolate”toallregisteredHSUs.Itwillof
course,be“pickedup”bynewlyinstalledandregisteredHSUs.
• TheonlywaytochangetheOperatingChannelisbydeactivationandreactivation.
• ChannelBandwidthandChannelSelectionchangeswillallbesector‐wide.
• UseofAutomaticChannelSelectiononlymakessenseatconfigurationtime.Choosea
singlechannelbasedonwhatACSshows.UsetheSpectrumViewtool(Chapter24)to
helpyoumakeyourchoice.
TheAdva ncedbar(shownopen)enablesyoutochooseThro ughputModethatdetermines
howtheAdaptiveModulationmechanismworks.MaximumThro ughput(default)shouldbe
chosenifthroughputismoreimportantthanhigherdelay.Conversely,ReducedLatency
minimizesdelayattheexpenseoflowerthroughput.