Radwin 5000 HPMP - Page 206

RADWIN5000HPMPUserManual Release3.5.70 8‐51
ChangingtheSectorBand
7.ClickOK.Asectorre‐syncfollows.Hereisthefinalresult:
Havingsetthechannelbandwidthandoperatingchannelsearlier,thereisnoneed
fordeactivationandreactivation.
YoumayalsoaddnewBandsbyclickingtheAddBandsbutton.Thereareseveralprovisosto
this:
• AdditionalBandsmustbeavailableforyourhardware
• SuchadditionalBandsmustbeavailablewithintheframeworkofyourlocalregulations
TheforegoingappliestobothregulatedandunregulatedBands.
 Toobtainandinstalladditionalbands:
1.MakealistofODUserialnumbersforallHBSsandallHSUstoreceiveadditional
bands.Thelistshouldbeasimpletextfile,oneserialnumberperline.(Theserial
numbersarelocatedonthestick ersontheODUs.)
2.AsInstaller,open
thewindowofFigure 8‐22above,andclickAddBands.The
followinginstructionpanelisdisplayed: