Radwin 5000 HPMP - Page 34

RADWIN5000HPMPUserManual Release3.5.70 3‐5
RFPlanningforDenseInstallationsandCollocatedSites
• IfoneormorecollocatedunitsarenotRADWINunits,ensurethatthereisaphysical
separationofatleastthreemetersbetweenaRADWINunitandanyothercollocated
radioonthesite.
• Usethelargestpossiblefrequencygapbetweentheseunits
• Choosethebestfrequencychannel(asclearaspossiblefrominterference).Youmaybe
abletochangethebandusedforthesector‐dependingonHBSmodelandregulations.
• DecreasingtheTxPowerofasectorwillreducecollocationinterference
Note
UsetheLinkBudgetCalculatortodeterminetheminimumTxPower
requiredtomaintainsectorstability.