Radwin 5000 HPMP - Page 348

RADWIN5000HPMPUserManual Release3.5.70 21‐3
SettingupanHSUforQoS
Ifyouun‐checkaqueue,itwillbedisabledforthesector.ItwillnotpreventtheHSUfrom
configuringitas“live”.ThepurposebehindthisistoavoidthenecessityofreconfiguringQoS
foreachHSU,shouldthequeuebereinstated.
SettingupanHSUforQoS
QoSsetupforanHSUiscarriedoutfromtheHBS.
 ToconfigureanHSUforQoS:
1.RightclickanHSUintheHBSmanagerHSUwindow,andchooseConfiguration.
2.OpentheEthernettabandclickQoSConfiguration.Thefollowingwindowis
displayed:
3.EnsurethattheModefieldisEnabled.IfyoualreadyconfiguredtheHBS(sector)for
DiffservorVLAN,thenitwillbeenabledbydefault.Ifyouneedtochangethemode,
thenyouprobablydidnotsetthesectorwideQoStype‐butyoucangobackanddo
itlater.