Radwin 5000 HPMP - Page 368

RADWIN5000HPMPUserManual Release3.5.70 24‐3
SpectrumViewMainWindow:HBS
UsethetopleftpaneltosettheSpectrumViewconfigurationparametersandchoosean
analysistype‐EntireSectororSpecificHSU.
Thesettingsar e“sticky”fortheHBSandwillbereused.Theanalysisrangeislimitedfrom
4900to6050MHzwithamaximumdifferenceof500MHz.Erroneousentrieswillbeshown
witharedborderlikethis:
Thetimeoutisthemaximumanalysistimepersite.Usethebottombuttonbartostartan
analysis,tostoparunninganalysisorrunaHighestInterferenceprofileforthesector:

IfyouchoosetoruntheanalysisforspecificHSUs,ThelefthandHSUpanelwillchange: