Radwin 5000 HPMP - Page 90

RADWIN5000HPMPUserManual Release3.5.70 5‐21
UsingtheMapView
 TorelocateaHBSorHSUbysettinglatitudeandlongitudecoordinates:
1.RightclicktheHBS(Bach@HBS.01)toopenitsContextmenuandthenConfigure.
2.ClicktheCoordinatesbuttontoopentheCoordinateswindowandentertherequired
latitudeandlongitude.
Youmayenterthecoordinatesindecimalordegrees/minutes/secondsusingthe
inputtemplateshownbelow:
3.HBSonly:TheAzimuthandBeamWidthdeterminethesectorcenter‐linedirection
andangleTheyareonlyusedforinitialdefaultdistributionofHSUsonthe map.
4.ClickOK.Theunitismovedtothenewlocation(possiblyoff‐screen).
5.Repeat
thepreviousfourstepsforeachHSUinthesector.Ifattheendoftheprocess,
theHBSisoff‐screen,clicktheCenteronSectorbuttonto“fly”tothesector.
UsingtheexampleinTable 5‐7,hereistheoutcome: