R&S SMA100A - Instrument Initialization

HP8373 emulation mode
1GP71_0E 108 Rohde & Schwarz
Status Command / Function / Remark / Limitation
STATus:PRESet
Preset the operation and questionable register contents.
STATus:QUEStionable:CONDition?
Query the condition bits of the questionable status register.
Value:
0 … 32757
STATus:QUEStionable:ENABle value
Set / Query the enable bits of the questionable status register.
Value:
0 … 32757
Default:
0
STATus:QUEStionable[:EVENt]?
Query the event bits of the questionable status register.
Value:
0 … 32757
STATus:QUEStionable:NTRansition value
Set / Query the negative transition filter bits of the questionable status register.
Value:
0 … 32757
Default:
0
STATus:QUEStionable:PTRansition value
Set / Query the positive transition filter bits of the questionable status register.
Value:
0 … 32757
Default:
32757
Table 103: Status register commands
Instrument initialization
The (factory) default setting of the HP8373 is applied and activated when
o applying the DCL, SDC to the GPIB interface.
o transmitting the *RST command
The (factory) default settings are listed under keyword “Default” in the
corresponding command.