R&S SMA100A - GPIB Functions; Commands; Common

HP8648 emulation mode
1GP71_0E 133 Rohde & Schwarz
GPIB functions
The following table shows the GPIB functions, supported by the HP8648.
Status Function Function / Remark / Limitation
DCL Device clear.
GTL Goto local mode.
IFC Interface clear.
LLO Local lockout.
PPC Parallel-Poll configure.
PPU Parallel-Poll unconfigure.
REN Goto remote mode.
SDC Selective device clear.
SPD Serial-Poll disable.
SPE Serial Poll enable.
SRQ Request service.
Table 128: GPIB functions
Commands
The following table shows the commands, supported by the HP8648
• Common
Status Command / Function / Remark / Limitation
*CLS
Clear the status register.
*ESE value
Set / Query the bits of the extended status enable register.
*ESR?
Query the bits of the extended status register.
*IDN?
Query the ID string.
Remark:
ID string has to be provided in frontpanel.
*OPC
*OPC?
*RCL value
Recall an instrument setup.
*RST
Reset the instrument to a default state.