R&S SMA100A - Frequency Subsystem

HP8360 emulation mode
1GP71_0E 84 Rohde & Schwarz
Status Command / Function / Remark / Limitation
FM:STATe value
Set / Query the (activation) state of the modulation.
Value:
ON | OFF | 1 | 0
Default:
OFF
Table 74: FM subsystem
• FREQuency Subsystem
Status Command / Function / Remark / Limitation
FREQuency:CENTer value
Set / Query the rf center frequency (in sweep mode).
Value:
num [HZ | KHZ | MHZ | GHZ] | MAXimum | MINimum
Fmin _ num _ Fmax
Default:
0.5 * (Fmax + Fmin)
Remark:
MAXimum, MINimum is not supported.
FREQuency[:CW | :FIXed] value
Set / Query the rf fixed frequency.
Value:
num [HZ | KHZ | MHZ | GHZ] | MAXimum | MINimum
Fmin _ num _ Fmax
Default:
0.5 * (Fmax + Fmin)
Remark:
MAXimum, MINimum is not supported.
FREQuency:CW:AUTO value
FREQuency:MANual value
Set / Query the manual (current) rf frequency (in sweep mode).
Value:
num [HZ | KHZ | MHZ | GHZ] | MAXimum | MINimum
Fmin _ num _ Fmax
Default:
0.5 * (Fmax + Fmin)
Remark:
MAXimum, MINimum is not supported.